EASU: New Technique - ATC Master Board Swap #3

Here is a master board technique that is a little bit different than what we have been doing. I hope you enjoy it!

You will create a rubber stamp & ink master board using the technique shown HERE.

If you cut your master board into ATC sizes you will end up with 9 pieces that are 2 1/2" x 3 1/2". Send 2 ATC's made from the same master board to both of your partners...that's 4 ATC's total.

You can still create the ATC's using just the master board you created OR you can cut your ATC from the master board & add additional embellishments to it. Either way is fine.

The Twinchies I created above was made using the same master board technique.

LMK if you have any questions. Thanks!!